Factors that drive wind power

Published on: 

Wind is good, anytime…anywhere! I like how they look and I like what they do.

 

But, have you ever noticed that all the success claims relate to how much wind capacity has been 

installed, rather than how much power that has been generated.

 

To illustrate, here’s some recent data on installed capacity:

Advertisement

There is some information available on wind energy penetration into the overall electricity 

consumption. AS can be seen from the chart shown below, the U.S., as a point of comparison indicates 

that wind accounted for just under 5% of electricity consumption in 2013, an approximate 4x increase 

over 2006.

In terms of Climate Change impact and specifically in terms of the CO2 emissions profile, load factor is 

more interesting. Wikipedia provides some wind data by country, tabulated below.

The data suggests that load factors typically vary between 20% and 30%.  No surprise here.  Most of 

these wind projects tend to be driven by first cost and today these wind assets are backed-up by natural 

gas-fired, simple-cycle gas turbines to manage the intermittent wind resource. These types of simple 

cycle units are required by the EPA New Source Performance Standard to not exceed 1100 lb-CO2/MWh.

 

The combined effect of 30% at zero lb-CO2/MWh, plus 70% at 1100 lb-CO2/MWh, would deliver 770 lb-

CO2/MWh in the best case, but some of these simple cycle units operating at part or varying load 

struggle to meet 1100 lb-CO2/MWh and at a 20% load factor, that combination would yield a value 

closer to the combined cycle CO2 threshold without abatement of 1000 lb-CO2/MWh.